Over-flowing Gutters

Golden Hammer Roofing recommends observing your gutter and downspout systems during rain. If the downspout is not expelling water at the bottom, it is likely clogged and may require cleaning. It's best to clean the gutters before diagnosing and repairing any issues. It is less expensive to have the gutters cleaned than to have them repaired, so it's wise to eliminate this possibility first.

 

Gutter Cleaning Maintenance

Not regularly cleaning gutters can lead to numerous issues, mainly caused by debris blockages. These problems can eventually result in expensive repairs. To avoid this, it is recommended to have a gutter cleaning service done every fall. Failure to remove debris can result in clogged downspouts that lead to water accumulation during storms, putting a strain on the seamless gutter systems and their fasteners.

 

Water Damage

Gutters that are damaged pose a significant threat to various parts of your home, such as the foundation, drywalls, window frames, siding, and wood trim. The primary function of gutter systems is to gather rainwater that falls from the roof and direct it away from the foundation. If water flows behind the gutter systems, seeps through their seams, or spills over their edges, it can lead to the degradation of the home in multiple ways. At Golden Hammer Roofing, we possess the expertise necessary to identify any issues with your gutters and provide homeowners with an economical solution.

Downspout Repairs

The downspout functions as a vertical pipe that directs water from the gutter to the ground. With time, the brackets used to fasten the downspout to a wall may loosen, causing it to dangle or even collapse. It is common for downspouts to become disconnected during severe winds or if they are bumped by someone. In such instances, the downspout must be firmly reattached to the wall using new hardware and, in some cases, fresh downspout straps. Golden Hammer Roofing is capable of reconfiguring, replacing, or re-securing downspouts on any exterior wall design. However, if the downspout is dented or crimped, it cannot be repaired and must be replaced. If the dents are severe enough to restrict the flow of water or allow debris to accumulate inside the pipe, replacement is necessary. Additionally, Golden Hammer Roofing often advises homeowners to extend upper downspouts, which discharge onto lower roofing surfaces, directly into the lower gutter system. This extension helps to contain water and protect the roof from further damage caused by upper-level downspouts.

Gutters Are Leaking

Different types of gutter leaks can indicate different things.  For example, overflowing, leaking, or dripping near a downspout often indicates a clogged gutter and/or downspout. Whereas water leaking from a gutter corner usually indicates a bad seal and/or potential gutter pitch issues. Identifying the cause of the leaks often requires an examination of the gutter system. When a gutter corner leaks, it means the sealant has failed. However, usually there is a cause for the sealant to fail in one area and not others. The most common cause for this issue is when the gutters are not pitched correctly. Water accumulating and resting in the gutters from not being able to drain eats through the sealant and causes the sealant to deteriorate over time and eventually fail.

Miter Repair/Replacement

When two separate sections of seamless gutter come together to form a corner an aluminum miter is used to bridge the gap. Miters are sealed with waterproof sealant to contain the water within the system and to prevent the water from leaking. The problem is that miter seals deteriorate over time and eventually fail. Once the sealant fails then the water will leak from that area when it rains. Golden Hammer Roofing can re-seal your existing miters that are leaking during a gutter cleaning service or as a separate repair service.  In some situations, the aluminum miters may need to be replaced. There are times when miters are beyond repair, and they need to be replaced. If there is a bend, tear, or fold in any component of the aluminum gutter system the piece more than likely will need to be replaced.

Fascia Board Repair/Replacement

The wood that your gutters are mounted to around the home is called fascia board. Over time this wood will rot and get soft. Once this happens it can’t support the weight of the gutters and the gutters get loose. If not taken care of the gutters can fall or blow off the home. Or even worse, the gutters could pull the fascia board right off the home. The only solution to rotted or damaged fascia board, is to replace the section with new fascia board or rake board.